Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX ACTIV, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION - 8T45 (MGH) - SPECIFICATIONSSPECIFICATIONSRANGE REFERENCE
2025 Chevrolet Equinox ACTIV, 4WD
Range Reference
2025 Chevrolet Equinox ACTIV, 4WDSECTION Range Reference
| Range | Gear 9Txx |
Gear 8Txx |
1-2-3-4-5-6 Clutch | 2-9 Clutch | 3-8 Clutch | 4th Clutch (9Txx only) | 5-7-Reverse Clutch | 6-7-8-9 Clutch | Selectable One Way Clutch (SOWC) |
|---|---|---|---|---|---|---|---|---|---|
| Park | P | P | - | - | - | - | - | - | - |
| Reverse | R | R | - | - | - | - | G | - | Holding |
| Neutral | N | N | - | - | - | - | - | - | O |
| Drive | 1st | 1st | G | - | - | - | - | - | Holding |
| 2nd | 2nd | Applied | Applied | - | - | - | - | - | |
| 3rd | 3rd | Applied | - | Applied | - | - | - | - | |
| 4th | N/A | Applied | - | - | Applied | - | - | - | |
| 5th | 4th | Applied | - | - | - | Applied | - | - | |
| 6th | 5th | Applied | - | - | - | - | Applied | - | |
| 7th | 6th | - | - | - | - | Applied | Applied | - | |
| 8th | 7th | - | - | Applied | - | - | Applied | - | |
| 9th | 8th | - | Applied | - | - | - | Applied | - | |
| O = On but not carrying a load G = Garage-shift element, on and carrying load |
|||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.