Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
Connect the electrical connectors.
- Restraints Control Module (2) - Install
- Airbag Sensing and Diagnostic Module Nut (1) - Install and tighten [3x] - Fastener Specifications
Floor Rear Air Outlet Duct - Front (2) @ Floor Rear Air Outlet Duct - Rear (3) - Install
- Push Pin (1) - Install
Floor Rear Air Outlet Duct - Left Side (2) - Install
- Push Pin (1) - Install [2x]
Front Floor Console Rear Air Duct - Front (2) - Install
- Retainer (1) - Install
- Front Floor Console - Install - Front Floor Console Removal and Installation
- Enable the SIR System. SIR Disabling and Enabling
- Perform the necessary programming and setup procedure: Control Module References
Refer to Fastener Caution .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.