Installation Procedure

2025 Chevrolet Equinox ACTIV, 4WDSECTION Installation Procedure
  1. GM6432031Courtesy of GENERAL MOTORS COMPANY

    Fuel Pump Power Control Module (3) - Install

  2. CAUTION:

    Refer to Fastener Caution .

  3. Fuel Pump Power Control Module Bolt (2) - Install and tighten - Fastener Specifications
  4. Fuel Pump Power Control Module Nut (1) - Install and tighten - Fastener Specifications
  5. Connect the electrical connector.
  6. Underbody Rear Air Deflector - Install - Underbody Rear Air Deflector Replacement
  7. Fuel Pump Power Control Module: Programming and Setup. K111 Fuel Pump Power Control Module: Programming and Setup
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.