Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX ACTIV, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASDRIVER ASSISTANCE SYSTEMSREPAIR INSTRUCTIONSSIDE OBSTACLE DETECTION CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2025 Chevrolet Equinox ACTIV, 4WD
Installation Procedure
2025 Chevrolet Equinox ACTIV, 4WDSECTION Installation Procedure
Ensure the retaining tabs are properly aligned.
- Side Object Sensing Alert Module (3) - Install
- Side Object Sensing Alert Module Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Connect the electrical connector. (1)
- Remove the support and lower the vehicle. Lifting and Jacking the Vehicle
- Perform the necessary programming and setup procedure: - Control Module References
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.