SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2025EQUINOX ACTIV, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSB218L SIDE OBSTACLE DETECTION CONTROL MODULE - LEFT: PROGRAMMING AND SETUPREPLACE AND PROGRAM ECU OR REPROGRAM ECU
2025 Chevrolet Equinox ACTIV, 4WD

Replace and Program ECU or Reprogram ECU

2025 Chevrolet Equinox ACTIV, 4WDSECTION Replace and Program ECU or Reprogram ECU

To program a replacement or an existing ECU, perform the following procedure:

NOTE:
  • Due to continuous improvements, the on screen selections may vary from instructions below.
  • Some systems only have one programmable Side Object Sensor Module.
  1. Ignition/Vehicle OFF
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select B218 Side Object Sensor Module then select B218R Right Side Object Sensor Module or B218L Left Side Object Detection.
  4. On the SPS Select Function / Sequence screen, select Sequential Programming or Programming
  5. Clear DTCs.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.