Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2025 Chevrolet Equinox ACTIV, 4WDSECTION Removal Procedure
Use a flat bladed plastic tool to remove.
- Instrument Panel Upper Trim Panel Cover (1) - Remove
Instrument Cluster Bolt (1) - Remove [4x]
- Disconnect the electrical connectors.
- Instrument Panel Cluster Control Module (2) - Remove
Radio Control Bolt (1) - Remove [4x]
- Disconnect the electrical connectors.
- Radio Control (2) - Remove
Disconnect the electrical connectors and reposition the wiring harness as necessary. (1)
Release the retaining tabs.
- Serial Data Gateway Module (1) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.