Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2025 Chevrolet Equinox ACTIV, 4WDSECTION Removal Procedure
- Disable the SIR system. SIR Disabling and Enabling
- Adjust the seat to gain access to the bolts.
Front Seat Bolt (1) - Remove [4x]
- Disconnect the electrical connector.
- Release the clips with a suitable tool.
- Front Seat (2) - Remove
Front Floor Console Extension Panel Bolt Access Hole Cover (1) - Remove
- Front Floor Console Extension Panel Bolt (2) - Remove
Front Floor Console Extension Panel- Left Side (1) - Remove
Disconnect the electrical connectors. (1)
Release the retaining tabs.
- Body Control Module (1) - Remove
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.