Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONAIR FLOW METER/SENSORSERVICE AND REPAIR
2013 Chevrolet Traverse FWD V6-3.6L
Air Flow Meter/Sensor: Service and Repair
2013 Chevrolet Traverse FWD V6-3.6LSECTION Service and Repair
Mass Airflow Sensor with Intake Air Temperature Sensor Replacement
Removal Procedure
1. Disconnect the engine wiring harness electrical connector from the mass air flow (MAF)/intake air temperature (IAT) sensor.
2. Remove the MAF/IAT sensor screws (1).
3. Remove the MAF/IAT sensor (2) from the air cleaner assembly.
Installation Procedure
1. Install the MAF/IAT sensor (2) to the air cleaner assembly.
Caution: Refer to Fastener Caution Fastener Caution.
2. Install the MAF/IAT sensor screws (1).
Tighten the screws to 4 Nm (35 lb in).
3. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.