Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTDIAGRAMSELECTRICAL DIAGRAMS
2013 Chevrolet Traverse FWD V6-3.6L
Electrical Diagrams
2013 Chevrolet Traverse FWD V6-3.6LSECTION Electrical Diagrams
Engine Controls Schematics
Power, Ground, Serial Data, and MIL
5V1, and Low Reference Bus (1 of 2)
5V2, 5V3, 5V4 and Low Reference Bus (2 of 2)
Engine Data Sensors- Throttle Controls
Engine Data Sensors- Pressure and Temperature
Engine Data Sensors- Oxygen Sensors
Ignition Controls- Bank 1 Ignition System
Ignition Controls- Bank 2 Ignition System
Ignition Controls- CKP, CMP, and Knock Sensors, and CMP Actuators
Fuel Controls- Fuel Injectors
Fuel Controls- Fuel Pump Controls
Fuel Controls- EVAP Controls
Controlled/Monitored Subsystem References
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.