Service Port HVAC: Service and Repair

2013 Chevrolet Traverse FWD V6-3.6LSECTION Service and Repair



Air Conditioning Refrigerant Service Valve Core Replacement

Special Tools

* GE 50078 - Electronic Leak Detector

* GE 46246 - Valve Core Tool

For equivalent regional tools. Refer to Special Tools Heating, Ventilation, and Air Conditioning.

Removal Procedure




1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging Refrigerant Recovery and Recharging.

2. Using the GE 46246 - Valve Core Tool, remove the valve core (1) from the service port.

Installation Procedure





Caution: Refer to Fastener Caution Fastener Caution.

1. Install the valve core (1) to the service port.

2. Using the GE 46246 - Valve Core Tool, tighten the valve core.

3. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging Refrigerant Recovery and Recharging.

4. Leak test the fittings of the component using GE 50078 - Electronic Leak Detector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.