Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISDIAGRAMSEXPLODED VIEWSAUTOMATIC TRANSMISSION/TRANSAXLEBUSHING, BEARING, AND WASHER LOCATIONS
2013 Chevrolet Traverse FWD V6-3.6L
Bushing, Bearing, and Washer Locations
2013 Chevrolet Traverse FWD V6-3.6LSECTION Bushing, Bearing, and Washer Locations
Bushing, Bearing, and Washer Locations
Bushing and Bearing Locations
32 - Input Shaft Thrust Bearing Assembly
214 - Drive Sprocket Thrust Washer
219 - Drive Sprocket Thrust Washer
220 - Drive Sprocket Thrust Washer
223 - Front Differential Drive Pinion Gear Bearing Thrust Washer
227 - Front Differential Bearing Thrust Washer
437 - 4-5-6 Clutch Hub Thrust Bearing Assembly
465 - 2-6 Clutch Hub Thrust Bearing
468 - Input Carrier Thrust Bearing Assembly
469 - Input Sun Gear Thrust Bearing Assembly
472 - Output Carrier Thrust Bearing Assembly
473 - Output Carrier Thrust Bearing Assembly
476 - Front Differential Transfer Drive Gear Input Hub Bearing Assembly
480 - Front Differential Drive Pinion Gear Bearing Assembly
485 - Front Differential Carrier Bearing Assembly
487 - Front Differential Carrier Bearing Assembly
488 - Front Differential Carrier Thrust Washer
492 - Front Differential Side Gear Thrust Washer
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.