Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINTRANSFER CASESERVICE AND REPAIROVERHAULOVERHAUL PROCEDURE STEPS
2013 Chevrolet Traverse AWD V6-3.6L
Overhaul Procedure Steps
2013 Chevrolet Traverse AWD V6-3.6LSECTION Overhaul Procedure Steps
Transfer Case Overhaul
NOTE: This article lists the sequential steps necessary to overhaul the transfer case.
^ For the specific step listed below, refer to that step under "Overhaul (Unit Repair)". Overhaul (Unit Repair)
1. Transfer Case Disassemble
2. Transfer Case Cleaning and Inspection
3. Rear Output Drive Housing Cleaning and Inspection
4. Input Shaft Seal Replacement - Right
5. Input Shaft Seal Replacement - Left
6. Front Drive Axle Inner Shaft Seal Replacement
7. Input Shaft and Rear Output Drive Shaft Cleaning and Inspection
8. Transfer Case Assemble
NOTE: This article lists the sequential steps necessary to overhaul the transfer case.
^ For the specific step listed below, refer to that step under "Overhaul (Unit Repair)". Overhaul (Unit Repair)
1. Transfer Case Disassemble
2. Transfer Case Cleaning and Inspection
3. Rear Output Drive Housing Cleaning and Inspection
4. Input Shaft Seal Replacement - Right
5. Input Shaft Seal Replacement - Left
6. Front Drive Axle Inner Shaft Seal Replacement
7. Input Shaft and Rear Output Drive Shaft Cleaning and Inspection
8. Transfer Case Assemble
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.