Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLEFLUID PANSPECIFICATIONS
2013 Chevrolet Traverse AWD V6-3.6L
Fluid Pan: Specifications
2013 Chevrolet Traverse AWD V6-3.6LSECTION Specifications
The holes in the control valve body cover wiring connector hole seal must face toward the control solenoid valve assembly. If the holes face toward the valve body cover, there is a potential for a leak around the seal.
Install all control valve body cover bolts and studs by hand then torque all bolts and studs in sequence.
Install the 12 control valve body cover bolts (1) M6 x 30.
Tighten the bolts in sequence to 12 Nm (106 lb in).
Install the 2 control valve body cover studs (2) M6 x 30.
Tighten the studs in sequence to 12 Nm (106 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.