Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSGENERAL ELECTRICAL DIAGNOSTIC PROCEDURESCONNECTOR REPAIRSREPAIRING CONNECTOR TERMINALS (TERMINATED LEAD REPAIR)
2013 Chevrolet Traverse AWD V6-3.6L
Repairing Connector Terminals (Terminated Lead Repair)
2013 Chevrolet Traverse AWD V6-3.6LSECTION Repairing Connector Terminals (Terminated Lead Repair)
Repairing Connector Terminals (Terminated Lead Repair)
Special Tools
EL-38125-10 - Splice Sleeve Crimp Tool
For equivalent regional tools, refer to Special Tools Tools and Equipment.
Note: All repairs near the engine manifold, turbo engine and all exhaust pipes should follow the High Temperature Wiring Repairs procedures.
For high temperature wiring repairs, refer to High Temperature Wiring Repairs High Temperature Wiring Repairs.
Terminated leads are terminals that are crimped onto wires. The terminated lead can be used throughout the vehicle since it is designed for temperatures up to 150°C. The length of the wire is 450 mm.
1. Use the connector end view to identify the correct terminated lead.
2. The terminated lead package should include a DuraSeal splice sleeve. If not, use the chart to in Splicing Copper Wire Using Splice Sleeves to identify the correct DuraSeal splice sleeve, refer to Splicing Copper Wire Using Splice Sleeves Splicing Copper Wire Using Splice Sleeves.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.