Valve Rocker Arm Replacement - Left Side

2013 Chevrolet Traverse AWD V6-3.6LSECTION Valve Rocker Arm Replacement - Left Side



Valve Rocker Arm Replacement - Left Side

Removal Procedure

1. Remove the applicable camshaft(s). Refer to Camshaft Replacement - Left Side Camshaft Replacement - Left Side.





2. Remove the rocker arms. Refer to Valve Rocker Arm Removal - Left Side (LLT) Valve Rocker Arm Removal - Left Side (LLT).

3. Clean and inspect the camshaft(s) and the rocker arm(s). Repair or replace as necessary. Refer to Camshaft Cleaning and Inspection Camshaft Cleaning and Inspection and Valve Rocker Arm Cleaning and Inspection Valve Rocker Arm Cleaning and Inspection.

Installation Procedure





1. Install the rocker arms. Refer to Valve Rocker Arm Installation - Left Side (LLT) Valve Rocker Arm Installation - Left Side (LLT).

2. Install the applicable camshaft(s). Refer to Camshaft Replacement - Left Side Camshaft Replacement - Left Side.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.