Rear Wheel Speed Sensor Replacement

Rear Wheel Speed Sensor Replacement

Warning:
Refer to Brake Dust Warning Brake Dust Warning.


Note:
If replacing the wheel speed sensor due to a DTC, inspect the back of the wheel bearing on the encoder surface for metallic chips or metal shavings. If metallic debris is found, clean the encoder surface to prevent interference with the wheel speed sensor signal and setting of a DTC. Refer to Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle to verify and clear the DTC.

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Removal and Replacement.

3. Disconnect the wheel speed sensor electrical connector (1).

4. Release the wheel speed sensor wire harness grommet (2) from the lower control arm bracket.

5. Release the wheel speed sensor wire harness routing clips (3) from the upper suspension link.





Note:
Clean the wheel speed sensor mounting area on the wheel knuckle of any accumulated dirt and debris.

6. Remove the wheel speed sensor bolt.

7. Pull the wheel speed sensor straight up and out of the wheel knuckle.

Installation Procedure





1. Install the wheel speed sensor to the wheel knuckle.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the wheel speed sensor bolt.

Tighten the bolt to 9 Nm (80 lb in).





3. Install the wheel speed sensor wire harness routing clips to the upper suspension link.





4. Install the wheel speed sensor wire harness routing clips (3) to the upper suspension link.

5. Install the wheel speed sensor wire harness grommet (2) to the lower control arm bracket.

6. Connect the wheel speed sensor electrical connector (1).

7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Removal and Replacement.

8. Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle.