Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISBODY AND FRAMESEATSSEAT TEMPERATURE CONTROL MODULELOCATIONSSEAT CUSHION VENTILATION HEATING AND COOLING MODULE - DRIVER (KB6)
2013 Chevrolet Traverse AWD V6-3.6L
Seat Cushion Ventilation Heating and Cooling Module - Driver (KB6)
2013 Chevrolet Traverse AWD V6-3.6LSECTION Seat Cushion Ventilation Heating and Cooling Module - Driver (KB6)
Passenger Compartment/Roof Component Views
Driver Seat Components (A45)
1 - Seat Front Vertical Motor - Driver
2 - Seat Front Vertical Motor Position Sensor
3 - Seat Rear Vertical Motor Position Sensor - Driver
4 - Seat Rear Vertical Motor - Driver
5 - Heated Seat Element - Driver Back
6 - Inflatable Restraint Side Impact Module - Left
7 - Seat Adjuster Switch - Driver
8 - Seat Lumbar Switch - Driver
9 - Seat Belt Pretensioner - Driver
10 - Seat Horizontal Motor - Driver
11 - Seat Horizontal Motor Position Sensor - Driver
12 - Seat Cushion Ventilation Heating and Cooling Module - Driver (KB6)
13 - Memory Seat Module (MSM)
14 - Seat Back Ventilation Heating and Cooling Module - Driver (KB6)
15 - Heated Seat Element - Driver Cushion
16 - Seat Belt Buckle - Driver
17 - Seat Recline Position Sensor - Driver
18 - Seat Recline Motor - Driver
19 - Seat Lumbar Horizontal Motor - Driver
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.