Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TAHOE 2WD V8-6.0L HYBRIDREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECONNECTING ROD, ENGINE
2013 Chevrolet Tahoe 2WD V8-6.0L Hybrid
Connecting Rod, Engine
2013 Chevrolet Tahoe 2WD V8-6.0L HybridSECTION Connecting Rod, Engine
Connecting Rod
Connecting Rod Bearing Clearance - Production 0.023-0.065 mm (0.0009-0.0025 in)
Connecting Rod Bearing Clearance - Service 0.023-0.076 mm (0.0009-0.003 in)
Connecting Rod Bore Diameter - Bearing End 56.505-56.525 mm (2.224-2.225 in)
Connecting Rod Bore Out-of-Round - Bearing End - Production 0.004-0.008 mm (0.00015-0.0003 in)
Connecting Rod Bore Out-of-Round - Bearing End - Service 0.004-0.008 mm (0.00015-0.0003 in)
Connecting Rod Side Clearance 0.11-0.51 mm (0.00433-0.02 in)
Connecting Rod Bolts
Tighten the bolts a first pass to 20 Nm (15 lb ft)
Tighten the bolts a final pass 85 degrees
Connecting Rod Bearing Clearance - Production 0.023-0.065 mm (0.0009-0.0025 in)
Connecting Rod Bearing Clearance - Service 0.023-0.076 mm (0.0009-0.003 in)
Connecting Rod Bore Diameter - Bearing End 56.505-56.525 mm (2.224-2.225 in)
Connecting Rod Bore Out-of-Round - Bearing End - Production 0.004-0.008 mm (0.00015-0.0003 in)
Connecting Rod Bore Out-of-Round - Bearing End - Service 0.004-0.008 mm (0.00015-0.0003 in)
Connecting Rod Side Clearance 0.11-0.51 mm (0.00433-0.02 in)
Connecting Rod Bolts
Tighten the bolts a first pass to 20 Nm (15 lb ft)
Tighten the bolts a final pass 85 degrees
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.