Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TAHOE 2WD V8-6.0L HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSFUEL LEVEL SENSORSERVICE AND REPAIR
2013 Chevrolet Tahoe 2WD V8-6.0L Hybrid
Fuel Level Sensor: Service and Repair
2013 Chevrolet Tahoe 2WD V8-6.0L HybridSECTION Service and Repair
Fuel Level Sensor Replacement
Removal Procedure
1. Remove the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement Service and Repair.
2. Using a small pick like tool, push in the retainer (1) in order to disengage the electrical connector.
3. Remove the fuel level sensor electrical connector from the module cover.
4. Push the level sensor locking tangs (2) in towards the inside of the module bucket.
5. Slide the fuel level sensor up.
6. Remove the fuel level sensor from the module.
Installation Procedure
1. Install the fuel level sensor to the module.
2. Position and slide the fuel level sensor down.
3. Ensure that the level sensor tangs (2) are engaged at the bucket.
4. Install the fuel level sensor electrical connector to the module cover.
5. Ensure that the retainer (1) engaged the module cover.
6. Install the fuel tank module. Refer to Fuel Tank Fuel Pump Module Replacement Service and Repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.