Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2013SONIC L4-1.8LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINMANUAL TRANSMISSION/TRANSAXLESERVICE AND REPAIRPROCEDURES

2013 Chevrolet Sonic L4-1.8L

Procedures

2013 Chevrolet Sonic L4-1.8LSECTION Procedures

Transmission Fluid Level and Condition Check

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair

2. Remove the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement

3. Place a basin underneath the vehicle.

4. Clean away all dirt and debris from the transmission case plug.

5. Remove the transmission case plug (1). DISCARD the case plug.

6. Add transmission fluid until it seeps out of the plug hole.

Installation Procedure

Caution:
Refer to Fastener Caution Fastener Caution.

1. Install a NEW case plug (1) and tighten to 4Nm (35 lb in) plus 45-135 degrees.

2. Install the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement

3. Lower the vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.