Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SONIC L4-1.8LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSENSORS AND SWITCHES - COMPUTERS AND CONTROL SYSTEMSKNOCK SENSORSERVICE AND REPAIR
2013 Chevrolet Sonic L4-1.8L
Knock Sensor: Service and Repair
2013 Chevrolet Sonic L4-1.8LSECTION Service and Repair
Knock Sensor Replacement
Removal Procedure
1. Disconnect the negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.
2. Remove the 2 intake manifold bracket bolts (2, 3).
3. Unclip the wiring harness.
4. Remove the intake manifold bracket (1).
5. Remove the sensor bolt (1).
6. Disconnect the electrical wiring harness connector.
7. Remove the knock sensor (2) from the bracket (3).
Installation Procedure
1. Install the knock sensor (2) to the bracket (3).
Caution:
Refer to Fastener Caution Fastener Caution
2. Install the sensor bolt (1) and tighten to 20 Nm (15 lb ft).
3. Connect the electrical wiring harness connector.
4. Install the intake manifold bracket (1).
5. Clip in the wiring harness to the bracket.
6. Install the 2 intake manifold bracket bolts (2, 3) and tighten to 8 Nm (71 lb in).
7. Connect the negative cable to the battery. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.