SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SONIC L4-1.8LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLHYDRAULIC SYSTEMBRAKE FLUID LEVEL SENSOR/SWITCHSERVICE AND REPAIR
2013 Chevrolet Sonic L4-1.8L

Brake Fluid Level Sensor/Switch: Service and Repair

2013 Chevrolet Sonic L4-1.8LSECTION Service and Repair



Brake Fluid Level Indicator Switch Replacement

Removal Procedure

1. Disconnect the brake fluid level indicator switch electrical connector.





2. Using a small, flat-bladed tool, lift the locking tab on the underside of the brake fluid level indicator switch (1) and remove the switch.

3. Inspect the master cylinder reservoir for damage and replace, if necessary. Refer to Master Cylinder Reservoir Replacement Service and Repair.

Installation Procedure

1. Install the master cylinder reservoir, if removed. Refer to Master Cylinder Reservoir Replacement Service and Repair.





2. Install the brake fluid level indicator switch (1) by pressing the switch firmly into the brake master cylinder reservoir.

3. Connect the brake fluid level indicator switch electrical connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.