Body Side Window Replacement (Swing Out)

2013 Chevrolet Express 2500 V8-4.8LSECTION Body Side Window Replacement (Swing Out)



Body Side Window Replacement (Swing Out)

Removal Procedure

The latched side window is a one-piece assembly that includes the following components:

* The window

* The hinges

* The latch assembly





Warning:
Refer to Glass and Sheet Metal Handling Warning Glass and Sheet Metal Handling Warning.


1. Remove the screws that retain the latch to the vehicle.

2. Remove the nuts (3) that retain the hinge to the vehicle.

3. Remove the window assembly from the vehicle.

Do not replace the weatherstrip (2) unless the weatherstrip is damaged.

Installation Procedure





1. Install the window assembly to the vehicle.

Caution:
Refer to Fastener Caution Fastener Caution.

2. Install the nuts (3) that retain the hinge to the vehicle and tighten to 10 Nm (89 lb in).

3. Install the screws that retain the latch to the vehicle and tighten to 3 Nm (27 lb in).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.