Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISMAINTENANCEFLUIDSFLUID - DIFFERENTIALSERVICE AND REPAIRPROCEDURESFRONT DRIVE AXLE
2013 Chevrolet Express 2500 V8-4.8L
Front Drive Axle
2013 Chevrolet Express 2500 V8-4.8LSECTION Front Drive Axle
Front Axle Lubricant Level Inspection
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Inspect the front axle for leaks. Repair as necessary.
3. Clean the area around the front axle fill plug.
4. Remove the fill plug.
5. Inspect the oil level.
The oil level should be between 0-10 mm (0-0.38 in) below the bottom of the fill plug opening.
6. If the level is low, add oil until the level is even with the bottom of the edge of the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant Recommendations Fluids.
Caution:
Refer to Fastener Caution Fastener Caution.
7. Install the fill plug and tighten to 33 Nm (24 lb ft).
8. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.