Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013EXPRESS 1500 RWD V6-4.3LREPAIR AND DIAGNOSISMAINTENANCEFLUIDSENGINE OILSERVICE AND REPAIR
2013 Chevrolet Express 1500 RWD V6-4.3L
Engine Oil: Service and Repair
2013 Chevrolet Express 1500 RWD V6-4.3LSECTION Service and Repair
Engine Oil and Oil Filter Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the drain plug and drain the engine oil in a suitable container.
3. Remove the oil filter.
4. Inspect to ensure the engine oil filter gasket is removed.
Installation Procedure
1. Lubricate the oil filter gasket with clean engine oil.
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the oil filter and tighten to 30 Nm (22 lb ft).
3. Install the drain plug and tighten to 25 Nm (18 lb ft).
4. Lower the vehicle.
5. Fill the engine with the proper capacity and quality of engine oil. Refer to Approximate Fluid Capacities [1][2]Maintenance.
6. Operate the engine, check for leaks, and oil pressure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.