Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013EXPRESS 1500 RWD V6-4.3LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERSERVICE AND REPAIR
2013 Chevrolet Express 1500 RWD V6-4.3L
Keyless Entry Receiver: Service and Repair
2013 Chevrolet Express 1500 RWD V6-4.3LSECTION Service and Repair
Remote Control Door Lock Receiver Replacement
Removal Procedure
1. Remove the instrument panel (I/P) upper trim panel. Refer to Instrument Panel Upper Trim Pad Replacement Instrument Panel Upper Trim Pad Replacement.
2. Disconnect the electrical connector (2) from the door lock receiver (1).
3. Disengage the remote control door lock receiver (1) from the door lock receiver bracket.
4. Remove the door lock receiver.
Installation Procedure
1. Perform the following to install the door lock receiver (1) to the door lock receiver bracket.
Slide the tab on door lock receiver (1) into the door lock receiver bracket and snap into place to secure.
2. Connect the electrical connector (1) to the door lock receiver (2).
3. Install the I/P trim panel. Refer to Instrument Panel Upper Trim Pad Replacement Instrument Panel Upper Trim Pad Replacement.
4. Refer to Control Module References Control Module References for programming and setup information.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.