Engine Oil: Service and Repair

Engine Oil and Oil Filter Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Place a drain pan under the oil pan drain plug.

3. Remove the oil pan drain plug. Allow the oil to drain completely.

Caution:
Refer to Fastener Caution Fastener Caution.

4. Install the oil pan drain plug and tighten to 25 Nm (18 lb ft).





Warning:
Refer to Hot Exhaust System Warning Hot Exhaust System Warning.


5. Place the drain pan under the oil filter (1).

6. Remove the oil filter. Allow the oil to drain completely.

Installation Procedure





1. Lubricate the NEW oil filter gasket with clean engine oil.

2. Tighten the oil filter (1) to 25 Nm (18 lb ft).

3. Lower the vehicle.

4. Refill the engine oil. Refer to Approximate Fluid Capacities [1][2]Maintenance.

5. Start the engine and inspect for leaks.