Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Brake Pedal Position Sensor Learn
2013 Chevrolet Cruze L4-1.8LSECTION Brake Pedal Position Sensor Learn
Brake Pedal Position Sensor Learn
Brake Pedal Position Sensor Learn is a procedure for the ECM to determine the position of the brake pedal position sensor when the brake pedal is in the released position.
Note: The Brake Pedal Position Sensor Learn procedure is required when the following service procedures have been performed:
* An Engine Control Module Replacement
* A BPP Sensor Replacement
* Any repair procedure that effects the brake pedal position sensor alignment
1. Install a scan tool.
2. Monitor the ECM for DTCs with a scan tool. If other DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle for the applicable DTC that set.
3. Navigate to the scan tool Brake Pedal Position Sensor Learn command by selecting the following:
1. Module Diagnosis
2. Engine Control Module
3. Configuration/Reset Functions
4. Learn Functions
5. Brake Pedal Position Sensor Learn
4. Ignition ON, Engine OFF, transmission in Park, brake pedal in the fully released position, select Learn.
5. Verify Brake Pedal Position Sensor and Brake Pedal Position Sensor Learned Home Position are within.1 Volts.
6. Select Exit.
7. Perform the body control module (BCM) brake pedal position sensor calibration. Refer to Brake Pedal Position Sensor Calibration Testing and Inspection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.