Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CRUZE L4-1.8LREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYBATTERY TRAYSERVICE AND REPAIR
2013 Chevrolet Cruze L4-1.8L
Battery Tray: Service and Repair
2013 Chevrolet Cruze L4-1.8LSECTION Service and Repair
Battery Tray Replacement
Removal Procedure
1. Open the hood.
2. Remove the battery. Refer to Battery Replacement Removal and Replacement.
3. Unclip all wiring harness from the battery tray.
4. Unclip the engine control module bracket from the battery tray.
5. If equipped, unclip the radiator surge tank engine hose from the battery tray.
6. Unclip the battery current sensor (1) from the battery tray.
7. Remove the 3 battery tray bolts (1).
8. Remove the battery tray (2).
Installation Procedure
1. Install the battery tray (2).
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the 3 battery tray bolts (1) and tighten to 15 Nm (11 lb ft).
3. Clip in the battery current sensor (1) to the battery tray.
4. If equipped, clip in the radiator surge tank engine hose to the battery tray.
5. Install battery. Refer to Battery Replacement Removal and Replacement.
6. Clip in all wiring harness at the battery tray.
7. Clip in the engine control module bracket to the battery tray.
8. Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.