Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CRUZE L4-1.8LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSAUTOMATIC TRANSMISSION/TRANSAXLEFLUID PAN, A/T
2013 Chevrolet Cruze L4-1.8L
Fluid Pan, A/T
2013 Chevrolet Cruze L4-1.8LSECTION Fluid Pan, A/T
Install the control valve body cover wiring connector hole seal (4).
Install the control valve body cover gasket (3) to the control valve body cover.
Install all control valve body cover bolts and studs by hand then torque all bolts and studs in sequence.
Tighten the bolts in sequence to 12 Nm (106 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.