Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CRUZE L4-1.4L TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMCAMSHAFT POSITION SENSORSERVICE AND REPAIR
2013 Chevrolet Cruze L4-1.4L Turbo
Camshaft Position Sensor: Service and Repair
2013 Chevrolet Cruze L4-1.4L TurboSECTION Service and Repair
Camshaft Position Sensor Replacement
Removal Procedure
1. Open hood.
Note:
Graphic shows exhaust camshaft position sensor. Use same procedure for Intake camshaft position sensor.
2. Disconnect the camshaft position sensor wiring harness plug (1).
Note:
Graphic shows exhaust camshaft position sensor. Use same procedure for Intake camshaft position sensor.
3. Remove the camshaft position sensor bolt (3).
4. Remove the camshaft position sensor (2) and the seal ring (1).
Installation Procedure
Note:
Graphic shows exhaust camshaft position sensor. Use same procedure for Intake camshaft position sensor.
1. Install the camshaft position sensor (2) and the seal ring (1).
Caution:
Refer to Fastener Caution Fastener Caution
2. Install the camshaft position sensor bolt (3) and tighten to 8 Nm (71 lb in).
Note:
Graphic shows exhaust camshaft position sensor. Use same procedure for Intake camshaft position sensor.
3. Connect the camshaft position sensor wiring harness plug (1).
4. After replacement of an camshaft position sensor, use a scan tool to speed up learn function. Refer to Engine Control Module Programming and Setup Testing and Inspection
5. Close hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.