Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CRUZE L4-1.4L TURBOREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSMEMORY POSITIONING SYSTEMSTESTING AND INSPECTION
2013 Chevrolet Cruze L4-1.4L Turbo
Memory Positioning Systems: Testing and Inspection
2013 Chevrolet Cruze L4-1.4L TurboSECTION Testing and Inspection
Volatile Memory Programming
Electric Window Lifters
Move all the windows to the topmost position and hold the switch pressed down for 2 seconds.
Sliding Sunroof
Move the sliding roof to the respective end stops to recalibrate the sensors.
Initialize Steering Angle Sensor (Vehicles without ESP and with Electric Power Steering)
Warning
For vehicles with electric power steering (EPS) and without a vehicle stability enhancement program, the steering angle sensor MUST always be initialized after the battery has been disconnected. Failure to initialize the steering angle sensor could limit the operation of the EPS system and result in personal injury.
To ensure proper initialization of the EPS system, do the following:
1. The engine should be on with the vehicle stationary.
2. Turn the steering wheel counterclockwise until it stops.
3. Turn the steering wheel clockwise until it stops.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.