Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE V8-6.2L SCREPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSRELAYS AND MODULES - RESTRAINTS AND SAFETY SYSTEMSAIR BAG CONTROL MODULETESTING AND INSPECTION
2013 Chevrolet Corvette V8-6.2L SC
Air Bag Control Module: Testing and Inspection
2013 Chevrolet Corvette V8-6.2L SCSECTION Testing and Inspection
Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
Important:
The air bag indicator light may remain ON after the body control module (BCM), or sensing and diagnostic module (SDM) is replaced, and during the programming procedure for the BCM until after the procedure is completed, and the ignition key is cycled OFF and ON.
If the SDM is replaced you must setup the new SDM part number in the BCM. With a scan tool, select the SIR module setup. Select setup SDM Part Number in BCM and follow the on-screen instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.