Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE V8-6.2L SCREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGDISCHARGE AIR TEMPERATURE SENSOR / SWITCHSERVICE AND REPAIRDUCT AIR TEMPERATURE SENSOR REPLACEMENT - LOWER LEFT SIDE
2013 Chevrolet Corvette V8-6.2L SC
Duct Air Temperature Sensor Replacement - Lower Left Side
2013 Chevrolet Corvette V8-6.2L SCSECTION Duct Air Temperature Sensor Replacement - Lower Left Side
Duct Air Temperature Sensor Replacement - Lower Left Side
Removal Procedure
1. Remove the HVAC module. Refer to Air Conditioning and Heater Module Assembly Removal and Installation Service and Repair.
2. Disconnect the lower LH diagnostic test mode (DTM) sensor electrical connector.
Important:
Rotate the DTM sensor counterclockwise to disengage the sensor from the lower duct.
3. Remove the lower LH DTM sensor from the HVAC module.
Installation Procedure
Important:
Rotate the DTM sensor clockwise to engage the sensor to the lower duct.
1. Install the lower LH DTM sensor to the HVAC module.
2. Connect the lower LH DTM sensor electrical connector.
3. Install the HVAC module. Refer to Air Conditioning and Heater Module Assembly Removal and Installation Service and Repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.