Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE V8-6.2L SCREPAIR AND DIAGNOSISDIAGRAMSELECTRICAL DIAGRAMSPOWERTRAIN MANAGEMENTSYSTEM DIAGRAM
2013 Chevrolet Corvette V8-6.2L SC
System Diagram
2013 Chevrolet Corvette V8-6.2L SCSECTION System Diagram
Engine Controls Schematics (LS9)
ECM Power, Ground, MIL, and Serial Data
5V Bus
Low Reference Bus
BARO, ECT, IAT 2, MAF/IAT, MAP, and Supercharger Air Inlet Pressure Sensors
Heated Oxygen Sensors
Electronic Throttle Controls
Fuel Injectors
Fuel Pump Controls
EVAP Solenoids, FTP Sensor, and Supercharger Bypass Valve Solenoid
Ignition Controls - Bank 1 (Odd) Ignition Coils
Ignition Controls - Bank 2 (Even) Ignition Coils
Ignition Controls - CKP, CMP, and Knock Sensors
Controlled/Monitored Subsystem References
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.