Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE V8-6.2L SCREPAIR AND DIAGNOSISBODY AND FRAMEFRAMESKID PLATESERVICE AND REPAIR
2013 Chevrolet Corvette V8-6.2L SC
Skid Plate: Service and Repair
2013 Chevrolet Corvette V8-6.2L SCSECTION Service and Repair
Skid Bar Replacement
Removal Procedure
1.Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2.Remove the front fascia. Refer to Front Bumper Fascia Replacement Front Bumper Fascia Replacement .
3.Remove all related panels and components.
4.Support the radiator assembly.
5.Support the skid bar.
6.Remove the 4 bolts (1) attaching the skid bar to the frame rails.
7.Remove the skid bar.
8.Save all of the brackets, mounting studs, and accessories for transfer to the new skid bar.
Installation Procedure
1.Transfer all of the brackets, mounting studs, and accessories to the new skid bar.
2.Position the skid bar to the frame rails.
Caution:Refer to Fastener Caution .
3.Install the 4 bolts (1) attaching the skid bar to the frame rails.
TightenTighten the bolts to 50 N �m (36 lb ft).
4.Install all related panels and components.
5.Install the front fascia. Refer to Front Bumper Fascia Replacement Front Bumper Fascia Replacement .
6.Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.