Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CAPTIVA SPORT FWD L4-2.4LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSDESCRIPTION AND OPERATIONPOWER WINDOWS
2013 Chevrolet Captiva Sport FWD L4-2.4L
Power Windows
2013 Chevrolet Captiva Sport FWD L4-2.4LSECTION Power Windows
Power Windows Description and Operation
Power Window System Components
The power window system consists of the following components:
* Driver window switch
* Front passenger window switch
* Left rear window switch
* Right rear window switch
* Window regulator motors in each of the doors
Power Window System Controls
The power window system can be controlled by a power window up or down switch activation.
Driver Window Operation
When the ignition switch is in the RUN or ACCY position, or retained accessory power (RAP) is enabled and the driver window switch is pressed in the down position, battery positive voltage is applied to the window regulator motor causing the window to open. When the driver window switch is pressed in the up position, voltage is applied to the window regulator motor in the opposite direction and the window closes.
The driver window switch also controls the passenger windows.
Express Down Feature
The driver window will travel to the fully down position when the driver window switch is pressed past the first detent. Pressing the driver window switch to the up position will cancel the express down feature.
Lockout Switch Feature
The driver window switch has a lockout switch which disconnects the battery positive voltage to the left rear and right rear passenger window switches, disabling them.
Individual Window Operation
When the ignition switch is in the RUN or ACCY position, or retained accessory power (RAP) is enabled and the lockout switch is disengaged, battery positive voltage will be available at the passenger window switches. When an individual window switch is pressed in the down position, battery positive voltage is applied to the window regulator motor causing that window to open. When the individual window switch is pressed in the up position, voltage is applied to the window regulator motor in the opposite direction causing that window to close. The return path to ground is supplied through the inactive control circuit being normally grounded through the driver window switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.