Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CAPTIVA SPORT FWD L4-2.4LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLETESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSCONTROL SOLENOID VALVE AND TRANSMISSION CONTROL MODULE ASSEMBLY INSPECTION
2013 Chevrolet Captiva Sport FWD L4-2.4L
Control Solenoid Valve and Transmission Control Module Assembly Inspection
2013 Chevrolet Captiva Sport FWD L4-2.4LSECTION Control Solenoid Valve and Transmission Control Module Assembly Inspection
Control Solenoid Valve and Transmission Control Module Assembly Inspection
1. Verify the conditions listed below do not exist. Carefully inspect the control solenoid valve assembly connectors and pins (1, 2, 4, 6) for the condition. Repair or replace as necessary.
* Damage
* Bent pins
* Debris
* Broken retaining tab
* Contamination
2. Verify there is no metallic debris inside the connectors near the terminal pins. Clean as necessary.
3. Verify the control solenoid valve assembly solenoid leads (3) do not have contamination or metallic debris. Clean as necessary.
4. Verify the resistance between the leads of each solenoid is within the range in the table below, with the solenoids at room temperature. If the resistance of any solenoid is not within range, replace the Control Valve Body Assembly.
5. Inspect the 2 control solenoid valve assembly filter plate retaining tabs (5) for cracks and ensure proper tension when filter plate is attached.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.