Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINFLEX PLATESERVICE AND REPAIR
2012 Chevrolet Traverse FWD V6-3.6L
Flex Plate: Service and Repair
2012 Chevrolet Traverse FWD V6-3.6LSECTION Service and Repair
Engine Flywheel Replacement
Removal Procedure
1. Remove the transmission. Refer to Transmission Replacement (Front Wheel Drive) Transmission Replacement (Front Wheel Drive)Transmission Replacement (All Wheel Drive) Transmission Replacement (All Wheel Drive).
2. Remove the engine flywheel bolts and flywheel. Refer to Engine Flywheel Removal 11. Engine Flywheel Removal.
3. Clean and inspect the flywheel. Refer to Engine Flywheel Cleaning and Inspection 54. Engine Flywheel Cleaning and Inspection. If the flywheel teeth are damaged, inspect the starter for proper operation. Replace the starter if you find excessive wear or damage to the starter drive. Refer to Starter Replacement Service and Repair.
Installation Procedure
1. Install the engine flywheel and bolts. Refer to Engine Flywheel Installation 131. Engine Flywheel Installation.
2. Install the transmission. Refer to Transmission Replacement (Front Wheel Drive) Transmission Replacement (Front Wheel Drive)Transmission Replacement (All Wheel Drive) Transmission Replacement (All Wheel Drive).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.