Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISSPECIFICATIONSPRESSURE, VACUUM AND TEMPERATURE SPECIFICATIONSFUEL PRESSURE
2012 Chevrolet Traverse FWD V6-3.6L
Fuel Pressure
2012 Chevrolet Traverse FWD V6-3.6LSECTION Fuel Pressure
Fuel pressure
Ignition ON, engine OFF 345-690 kPa (50-100 psi)
Engine idling at normal operating temperature 300-400 kpa (43-58 psi)
Relieve the fuel pressure to 69 kPa (10 psi). Verify that the fuel pressure does not decrease greater than 14 kPa (2 psi) in 5 min
Note: DO NOT perform the Fuel System Diagnosis if the engine coolant temperature is above 60°C (150°F). High fuel pressure readings may result due to hot soak fuel boiling. With the engine OFF, the fuel pressure may increase beyond the pressure relief regulator valve's setting point of 690 kPa (100 psi) ± 5 percent.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.