Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISLIGHTING AND HORNSFOG/DRIVING LAMPSERVICE AND REPAIR
2012 Chevrolet Traverse AWD V6-3.6L
Fog/Driving Lamp: Service and Repair
2012 Chevrolet Traverse AWD V6-3.6LSECTION Service and Repair
Parking and Front Fog Lamp Bracket Replacement (Enclave)
Removal Procedure
1. Remove the front wheelhouse liner. Refer to Front Wheelhouse Front Liner Replacement.
2. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
3. Remove the lower front bumper fascia to bracket screw (1).
4. Remove the 3 upper and 3 lower screws (2).
5. Remove the lower push lock retainer (4) and bolt (3).
6. Release the two fog lamp bracket tabs from the front bumper fascia, push in order to release the tabs.
7. Remove the parking and front fog lamp bracket (1) from the front bumper fascia (2).
Installation Procedure
1. Position and align the parking and front fog lamp bracket (1) to inside the front bumper fascia (2).
2. Secure the locking tabs to the front bumper fascia.
Caution:
Refer to Fastener Caution Fastener Caution.
3. Install the lower push lock retainer (4) and bolt (3).
4. Install the 3 upper and 3 lower screws (2).
5. Install the front bumper lower fascia to bracket screw (1) and tighten to 2.5 Nm (22 lb in).
6. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement.
7. Install the front wheelhouse liner. Refer to Front Wheelhouse Front Liner Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.