Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAUL79. ENGINE FRONT COVER ASSEMBLE
2012 Chevrolet Traverse AWD V6-3.6L
79. Engine Front Cover Assemble
2012 Chevrolet Traverse AWD V6-3.6LSECTION 79. Engine Front Cover Assemble
Engine Front Cover Assemble
Special Tools
* EN-46103 - Camshaft Actuator Valve Seal Remover/Installer
* J 29184 - Output Shaft Seal Installer
Important: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.
1. Install the NEW crankshaft front oil seal into the engine front cover using the J 29184 - output shaft seal installer.
2. Place the seal into position with the notches (1) in the seal down. The notches (1) will face inboard when properly installed.
3. Install the NEW camshaft position actuator valve oil seals into the engine front cover using the EN-46103 - camshaft actuator valve seal remover/installer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.