Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAUL131. ENGINE FLYWHEEL INSTALLATION
2012 Chevrolet Traverse AWD V6-3.6L
131. Engine Flywheel Installation
2012 Chevrolet Traverse AWD V6-3.6LSECTION 131. Engine Flywheel Installation
Engine Flywheel Installation
Special Tools
* EN 46106 - Engine Flywheel Holding Tool
* J 45059 - Angle Meter
For equivalent regional tools, refer to Special Tools Special Tools.
1. Place the engine flywheel in position on the crankshaft.
2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.
3. Install the EN 46106 - tool.
Caution:
Refer to Fastener Caution Fastener Caution.
4. Install the remaining NEW engine flywheel bolts.
1. Tighten the NEW engine flywheel bolts to 30 Nm (22 lb ft).
2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the J 45059 - meter.
5. Remove the EN 46106 - tool.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.