Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAUL103. FUEL FEED PIPE INSTALLATION
2012 Chevrolet Traverse AWD V6-3.6L
103. Fuel Feed Pipe Installation
2012 Chevrolet Traverse AWD V6-3.6LSECTION 103. Fuel Feed Pipe Installation
Fuel Feed Pipe Installation
Caution:
Refer to Fastener Caution Fastener Caution.
1. Install the NEW LH to RH fuel rail crossover pipe and tighten the fittings to 30 Nm (22 lb ft).
2. Install the NEW fuel feed pipe.
3. Install the fuel feed pipe bolts and tighten to 10 Nm (89 lb in).
4. Install the fuel rail wiring connectors to the fuel feed pipe bracket.
5. Install the fuel rail noise shield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.