Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINEAPPLICATION AND ID
2012 Chevrolet Traverse AWD V6-3.6L
Engine: Application and ID
2012 Chevrolet Traverse AWD V6-3.6LSECTION Application and ID
Engine Identification
Vehicle Identification Number
The Vehicle Identification Number (VIN) Derivative is located in two places on the engine and is a nine digit number stamped or laser etched onto the block at the vehicle assembly plant. If reading the identification number the following information can be obtained:
* The first digit identifies the vehicle division.
* The second digit is the model year.
* The third digit identifies the assembly plant.
* The fourth through ninth digits are the last six digits of the Vehicle Identification Number (VIN).
The engine block is marked with the VIN on a pad area on the left rear side (1).
The engine block is marked with the VIN on a pad area on the center lower right side (1).
Engine Traceability Label
The engine traceability label is located in two places on the engine and consists of the broadcast code, bar code and sequence number.
One engine traceability label (1) is located on the left rear side of the engine block.
Another engine traceability label (1) is located on the rear of the left cylinder head.
Engine Verification Label
The engine verification label is located in two places on the engine and consists of the broadcast code and bar code.
One engine verification label (1) is located on the left side of the engine front cover below the exhaust camshaft position sensor.
Another engine verification label (1) is located on the rear of the right cylinder head.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.