Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012SONIC L4-1.4L TURBOREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - STEERING AND SUSPENSIONRELAYS AND MODULES - STEERINGSTEERING CONTROL MODULETESTING AND INSPECTION
2012 Chevrolet Sonic L4-1.4L Turbo
Steering Control Module: Testing and Inspection
2012 Chevrolet Sonic L4-1.4L TurboSECTION Testing and Inspection
Power Steering Control Module Programming and Setup
The following service procedures require either a programming or a setup event performed for a complete repair.
Power Steering Control Module Replacement
If the power steering control module needs to be replaced, the following procedures must be performed:
1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).
2. Perform the SPS function Electronic Power Steering - Prepare Control Module for Removal and follow the on-screen instructions.
3. Perform the SPS function Electronic Power Steering - Programming and follow the on-screen instructions.
4. Perform the SPS function Electronic Power Steering - Setup and follow the on-screen instructions.
5. Clear DTCs after completing the programming procedure.
Power Steering Control Module Reprogramming
Do not reprogram the power steering control module unless directed by a service procedure or a service bulletin.
1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).
2. Perform the SPS function Electronic Power Steering - Programming and follow the on-screen instructions.
3. Clear DTCs after completing the programming procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.