Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012SONIC L4-1.4L TURBOREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMSERVICE AND REPAIR
2012 Chevrolet Sonic L4-1.4L Turbo
Disc Brake System: Service and Repair
2012 Chevrolet Sonic L4-1.4L TurboSECTION Service and Repair
Front Brake Shield Replacement
Removal Procedure
Warning:
Refer to Brake Dust Warning Brake Dust Warning.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
3. Remove the front brake rotor. Refer to Front Brake Rotor Replacement (J93, J94) Removal and Replacement.
4. Remove the front brake shield bolts (1).
5. Remove the front brake shield (1).
Installation Procedure
1. Install the front brake shield (1).
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the front brake shield bolts (1) and tighten to 9 Nm (80 lb in).
3. Install the front brake rotor. Refer to Front Brake Rotor Replacement (J93, J94) Removal and Replacement.
4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.