Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012SILVERADO 2500 2WD V8-6.6L DSL TURBOREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSACCELERATOR PEDAL POSITION SENSORSERVICE AND REPAIR
2012 Chevrolet Silverado 2500 2WD V8-6.6L DSL Turbo
Accelerator Pedal Position Sensor: Service and Repair
2012 Chevrolet Silverado 2500 2WD V8-6.6L DSL TurboSECTION Service and Repair
Accelerator Pedal Position Sensor Replacement
Removal Procedure
Caution: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.
1. Remove the connector position assurance (CPA) retainer.
2. Disconnect the accelerator pedal position (APP) sensor electrical connector (1).
3. Remove the accelerator pedal bolts.
4. Remove the accelerator pedal.
Installation Procedure
1. Position the accelerator pedal to the accelerator pedal bracket.
Caution: Refer to Fastener Caution Fastener Caution.
2. Install the accelerator pedal bolts and tighten to 9 Nm (80 lb in)..
3. Connect the APP sensor electrical connector (1).
4. Install the CPA retainer.
5. Connect a scan tool to the diagnostic port in order to test for proper throttle-opening and throttle-closing range.
6. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
7. Verify that the vehicle meets the following conditions:
* The vehicle is not in a reduced engine power mode.
* The ignition is ON.
* The engine is OFF.
8. Inspect the carpet fit under the accelerator pedal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.