Air Bag Systems: Service Precautions

2012 Chevrolet Express 3500 V8-4.8LSECTION Service Precautions



SIR Service Precautions

Warning

When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.

The inflatable restraint sensing and diagnostic module (SDM) maintains a reserved energy supply. The reserved energy supply provides deployment power for the air bags. Deployment power is available for as much as 1 minute after disconnecting the vehicle power. Disabling the SIR system prevents deployment of the air bags from the reserved energy supply.

General Service Instructions

The following are general service instructions which must be followed in order to properly repair the vehicle and return it to its original integrity:

* Do not expose inflator modules to temperatures above 65°C (150°F).

* Verify the correct replacement part number. Do not substitute a component from a different vehicle.

* Use only original GM replacement parts available from your authorized GM dealer. Do not use salvaged parts for repairs to the SIR system.

Discard any of the following components if it has been dropped from a height of 91 cm (3 ft) or greater:

* Inflatable restraint sensing and diagnostic module (SDM)

* Inflatable restraint I/P module

* Inflatable restraint steering wheel module

* Inflatable restraint steering wheel module coil

* Inflatable restraint roof side rail modules

* Inflatable restraint side impact sensors (SIS)

* Inflatable restraint seat belt retractor pretensioners

* Inflatable restraint front end sensors

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.