Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012EXPRESS 3500 V8-4.8LREPAIR AND DIAGNOSISLIGHTING AND HORNSBRAKE LIGHT SWITCHSERVICE AND REPAIRBRAKE PEDAL POSITION SENSOR REPLACEMENT
2012 Chevrolet Express 3500 V8-4.8L
Brake Pedal Position Sensor Replacement
2012 Chevrolet Express 3500 V8-4.8LSECTION Brake Pedal Position Sensor Replacement
Brake Pedal Position Sensor Replacement
Removal Procedure
1. Place the ignition switch in the OFF position.
2. Disconnect the brake pedal position sensor electrical connector.
3. Remove the brake pedal position sensor bolt (1).
4. Remove the brake pedal position sensor (1.
Installation Procedure
1. Install the brake pedal position sensor (1.
Caution:
Refer to Fastener Caution Fastener Caution.
2. Install the brake pedal position sensor bolt (1).
3. Connect the brake pedal position sensor electrical connector.
4. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.